Connection Diagram

Example of connection 1

Power supply control system for 2 to 8 channels using one PIA4810

Example of connection 2

Power supply control system for 32 channels per one GPIB address using one PIA4810 and three PIA4820s

Example of connection 3

Power supply control system in which a power supply is directly connected to the system between two PIA 4820s (combination with power supply and power supply controllers)

Example of connection 4

Power supply control system using one PIA4830 (controls up to of 31 channels)

• When the power supply control system in “Example connection 2” is provided as a basic configuration, the additional use of GPIB addresses allows it to control a maximum of 448 channels. (32 channels x 14 addresses = 448 channels)
• The only models that can be directly connected for control to a power supply controller via a TP-BUS, as in “Example connection 3” or “4”, are DC power supplies with a digital remote-control function.
• When the power supply control system in “Example connection 4” is provided as a basis, the additional use of GPIB addresses allows it to control a maximum of 448 channels. (32 channels x 14 addresses = 448 channels) It is also possible to construct a system with the same connections using the PIA4810. Note:For PMR Series,up to 434 can be controlled. (31 channels x 14 addresses = 434 channels)
• It is limited to use a TP-BUS for connecting up to 3 units of PIA4820. In case, If you wish to connect more than three PAI4820s, please consult with KIKUSUI.
• The total extension length of the TP-BUS for connection is up to 200 m.
• For advice on other connections, please consult with KIKUSUI.